OVER RAFTER
APPLICATONS

Start at the bottom of the roof, at the eaves support tray/guttering. Ensure the SuperFOIL is properly aligned with the edge of the roof, then secure it by stapling the start of the roll to your rafter.

Once secured, you can begin to unroll the product out horizontally across the rafters.

As you go, it’s important to properly fix your insulation in place and to fully seal all joints, tears, and cuts using SuperFOIL Multifoil tape to ensure an airtight finish. Refer to the Full Installation Guide for specific guidance on how to properly cut, fix, and seal SuperFOIL products.

If you are using counter battens before installing your tile battens, which we highly encourage, then you should ensure that the insulation is pulled taut whilst being fixed into place to ensure the product doesn’t drape between the rafters.

Alternatively, if you decide to apply the tile battens directly to the insulation layer, you need to ensure that the product is draped between the rafters to create a 10mm gap (at least) under the tile battens to allow water run-off.